Lumen light guide

Three looks

Each picture below was made in Lumen light from its two sample pictures, with a preset and Replay, and caught partway through the run. The table lists the buttons pressed. A run moves, so a picture you save will be a different moment.

Shafts

A darkened, gold-haloed figure in pearls with faint beams of light falling from the upper left — Shafts a third of the way through: a darkened picture, with faint beams now falling from the upper left.

Press Shafts under Presets, then Replay at the top of the panel.

Tyndall mode with more haze and a darker picture than God rays. The light starts high on the right and swings once round the middle of the frame, and the beams turn with it. On these dark sample pictures the beams are faint; the darkening shows most.

Setting	Value
Presets	Shafts
Load and save	Replay

Raise Intensity towards 2 for stronger beams, or lower Base dim to keep more of the picture.

Corona

A gold-haloed figure in pearls with pinkish ghost copies of its pearls spreading out in streaks on both sides — Corona partway through: soft, streaky copies of the bright pearls spread out on both sides.

Press Corona under Presets, then Replay at the top of the panel.

Aureole mode with the strongest and warmest light of the two halo presets. Each pixel picks up light from a short way towards the light, so bright parts smear into soft streaks, and as the light swings round they move with it. At 3.4 seconds it is the slowest preset.

Setting	Value
Presets	Corona
Load and save	Replay

Move Warmth to 0 for a white glow.

Lantern

A pale figure before tall spires showing through the middle of a gold-haloed figure, outlined by a thick band of warm light — Lantern partway through: picture B shows through the middle first, ringed by warm light.

Press Lantern under Presets, then Replay at the top of the panel.

Alabaster mode. The order follows picture B: its light areas, here the pale figure, show through first and its broad dark areas last. A thick band of very warm light follows the edge between the two pictures.

Setting	Value
Presets	Lantern
Load and save	Replay

Lower Density for a sharper edge between the two pictures, or Intensity for a quieter band.